Purifying Drinking Water
Three Easy Ways to Purify Water
If you run out of stored, purified water you can always use the water stored in
your home water heater or plumbing.
In addition to having a bad odor and taste, contaminated water can contain
microorganisms and viruses that cause diseases such as dysentery, cholera,
typhoid and hepatitis. You should therefore purify all water of uncertain
purity before using it for drinking, food preparation or hygiene.
There are many ways to purify water. None are perfect. Often the best solution
is a combination of methods. Before purifying, let any suspended particles
settle to the bottom, strain them through layers of paper towel or clean cloth.
Three easy purification methods are outlined below. These measures will kill
microbes but will not remove other contaminants such as heavy metals, salts,
and most other chemicals.
Boiling is the safest method of purifying water. Bring water to
a rolling boil for two minutes, keeping in mind that some water will evaporate.
Let the water cool before drinking. Boiled water will taste better if you put
oxygen back into it by pouring it back and forth between two containers that
have been sanitized. This will also improve the
taste of stored water.
Chlorination uses unscented household liquid chlorine bleach to
kill microorganisms. Add two drops of bleach per quart of water (four drops if
the water is cloudy) , stir, and let stand for 30 minutes. If the water does not
taste and smell of chlorine at that point, add another dose and let stand for
another 15 minutes. This method will not kill all parasitic organisms.
Purification tablets release chlorine or iodine. They are
inexpensive and available at most sporting goods stores and some drugstores.
Follow the package directions. Usually one tablet is enough for one quart of
water. Double the dose for cloudy water. This method does not kill all
parasitic organisms.
There is also a more rigorous purification method that will remove other
contaminants:
Distillation will remove microbes, heavy metals, salts, and most
other chemicals. It involves boiling water and then collecting the vapor that
condenses back to water. The condensed vapor will not include salt and other
impurities. To distill, fill a pot halfway with water. Tie a cup to the handle
of the pot's lid so that the cup will hang right-side up when the lid is
upside-down. Put the lid on the pot upside-down (making sure the cup is not
dangling into the water), and boil the water for 20 minutes. The water that
drips into the cup from the lid is distilled.